#Cube pro duo price full
#Cube pro duo price mods
#Cube pro duo price software

The firmware for the Rumba board is located here: Slicers Speeds up to 100mm/s are possible extrusion wise, might not be so good for the frame thoughВ :). These hot-ends are also capable of high-speeds because they can put out a lot more volume than most hot-ends. The firmware is currently set to turn on both hot-end fans when either hot-end gets above 70C. The hot-ends have a teflon tube insert going down into the cold-zone but a 24V axial fan maintains a the cool termpature on the heatsink to prevent heat-creep which causes jams. This high temperature of the hot-end means its possible to print more exotic matierals such as Tritan from Taulman. These thermistors can take up to 295C, the firmware currently has a shut off if the hot-ends go above 290 degrees. The bracket for them is here and its recommended to print replacements in ABS or Colorfabb CF20. They are mounted in the extruderw from the original Cubex build.

Sometimes somebody rips out a thermistor and its a sad day, good to have backups, just in case.

#Cube pro duo price mods

The hot-ends the Cubex Duo mods have are e3d V6s, these hot-ends are installed with ATC Semitec 104GT-2 thermistors, which can be purchased here: and the Reprap wiki page for them is here: /wiki/Thermistor#ATC_Semitec_104GT-2.

#Cube pro duo price full

1x RepRapDiscount Full Graphic Smart Controller.For this you'll need some parts some of which are printed and some of which are bought. Once you've removed all of the components then you can proceed to start the actual build. In case they take down the datasheet I've also uploaded the datasheet to the RepRap wiki, get it here: The datasheet for the stepper can be found here: The stepper motors on all axes except for Z and extruders are M42STH38-1684S from Motion Control Products. A lot of people had trouble finding information on the stepper motors, I was able to find a data sheet on all of the steppers except for the Z-axis stepper which is a Nema 23. There are some things you should know about the existing machines in order to complete this build. The parts that I kept in place are the stepper motors, the endstops(at least the X and Y) and mechanical setup of the smooth rods, the frame and the outer casing. The first part of working with these machines essentially involves removing everything proprietary about them, that includes the electronics, the electronics mounted on the X-carriage, the filament spool cartridge readers in the bottom and for me I also removed the hot-ends, I've seen people that use the existing hot-ends but I wanted to be able to print high-temp materials and didn't want to deal with the fuss of a machine that is basically a RepRap with some unknown hot-end produced by 3Dsystems.

#Cube pro duo price software

This page will have links to all the files, parts and firmware configuration and software necessary to run these printers as RepRap machines rather than 3Dsystems machines. The electronics, LCD, power supply etc are replaced to produce a printer with a 300x300mm heated bed, 1, 2 or 3 hot-ends, a 24V power supply for the heated bed and electronics and stepper motors and a full graphic LCD controller with SD card support.

Check that out here: The point of this page is to show how the printer can be converted into an open source RepRap machine by stripping everything out of it except for the stepper motors, endstops, smoothrods and frame itself. The end result being an Amazon review page where 83% of the reviewers gave the product 1 star. The Cubex Duo and Cubex Trio are printers by 3D systems released sometime around 2012, 2013, with a hefty price tag and a proprietary system they created a lot of disappointment to customers.